skyking1
Senior Member
That stuff smells from way over here
We look at stuff like that and make a little pinch the nose sign.
We look at stuff like that and make a little pinch the nose sign.
Give the track tensioners on the D5 a couple of pumps some time when you have the grease gun out will ya....
Don't be surprised if it's idler bearingsThink the idler seal is going out. We've been pumping it up every few days but it slowly leaks back down but no visible sign of grease. Haven't had time to break the track and investigate.
Don't be surprised if it's idler bearings
Here to make Bridge Law, the 3 axle I have been running can only go 19T, the quads can up that to 22t and bump 24 if not on main highways.
So you guys have different weights that you can haul on highways and side roads?
Started a new project last week during the 2 spats of bad weather that the most recent spat spawned tornados that ripped through our county yesterday. It has rained 6 out of the last 10 working days. This project is located about 1/4 mile north of where an F3 passed over US HWY 280 yesterday.
Not my picture. Our job site is across the highway from this intersection, to the left of this pic. That tornado destroyed many, many houses in a subdivision right in front of it.
View attachment 236396
Brought the T250 out of semi-retirement to run the trencher as this job has 600' of silt fence. Used the 279D to carry T-posts, mash them into the ground and string wire while the T250 trenched away. Work smarter not harder - we hate manual labor.
View attachment 236394
Construction entrance down, silt fence installed and city inspection passed. Now we just need the rain and severe weather to subside but it's March in Alabama and it's just getting started.
View attachment 236395