• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

wiring problems

  1. W

    Cat 303CR will not start with key, blade only hydraulics when running.

    New here looking for some help. I have a 303CR, serial DMA-05055, which will not start with the key. I can jump the solenoid and the machine will run. However, I do not have any hydraulics accept for the blade. I believe the issue is in the safety switch circuit. Machine will shut off with...
    • Wen32FAB
    • Thread
    • cat 303cr safety switch wiring problems wiring schematic
    • Replies: 12
    • Forum: Excavators
  2. M

    Cat 299d3, machine in limp mode, several codes. E361-3, 2204-3pre-Nox Sensor?

    My 299D3 just went down on me. Started with no aux hyd code 2204-3. Then CAN Data Link=Pre-NOx Sensor. Now E361-3, Gauges never showed temps were warm or hot? Where do I start, machine has 800 hrs.
  3. J

    Mustang 519 Telehandler Gearshift Issue

    Lift will crank and shift into reverse but will blow a fuse immediately and shut down when placed in forward motion. lift boom will operate normal, no visible leaks or other problems detected. Could it be a possible wire short or any other ideas?
  4. C

    Timberjack 360 pops into neutral

    Hey guys been thru here a couple times browsing the internet looking for pointers, all here seem quite helpful. Been working on equipment for a while, this ones got me stumped. Did a search cant find anything quite exact to what this machine is going thru. Got a Timberjack 360 cable. Cummins...
Top