bodieman5112
New Member
running out of ideas-looking for some help
have 751 bobcat- peugoet engine that wont start (some backround - would ocassionally lose rpms when going up steep hill or loading on trailer) pulled out fuel tank tube(lovely design by the way) everything intact-- primer ball puts fuel to bleeder valve-- removed shutoff cyl, plunger moves freely-- cracked injector lines-has fuel coming out but not sure if enough?? engine puffs while cranking but not a lot-- tried squeezing primer ball while cranking, didn't make any difference- removed top half of covers to check timing, put bolt in camshaft and pump, belt looked ok so assuming it hadn't jumped time but couldn't see crank pulley mark because didn't pull that lower *#* cover. running out of ideas looking for some help?
have 751 bobcat- peugoet engine that wont start (some backround - would ocassionally lose rpms when going up steep hill or loading on trailer) pulled out fuel tank tube(lovely design by the way) everything intact-- primer ball puts fuel to bleeder valve-- removed shutoff cyl, plunger moves freely-- cracked injector lines-has fuel coming out but not sure if enough?? engine puffs while cranking but not a lot-- tried squeezing primer ball while cranking, didn't make any difference- removed top half of covers to check timing, put bolt in camshaft and pump, belt looked ok so assuming it hadn't jumped time but couldn't see crank pulley mark because didn't pull that lower *#* cover. running out of ideas looking for some help?