• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. 0

    Cat 257B battery drain

    Have a 3.00 amp draw after the key is turned off. It slowly lowers to about .4 over a 20 to 30 min period and by then the battery is down low enough that it won't start the machine. I pulled every fuse under the seat and the draw continued. Nige got me the diagram, so now I am looking for a...
  2. 0

    Fiatallis FG85A SN 71s00929

    Looking for information on this machine. Hopefully a manual that shows what solenoids are energized for what gear etc. and the electrical diagram. Transmission not shifting right, but I have not seen the machine yet. Anyone have a service manual for this machine or its transmission. I don't...
  3. 0

    Cat 320C Power Shift PRV calibration

    Read a lot of info on this site and the internet about calibrating the Pressure relief Valve, so I ordered a manual to get the full set of instructions. Waiting for the manual to come in. My question is - Do I have to have a computer and software to do this calibration, or is it done through...
  4. 0

    What engine is in this old Toyota FD150

    I am working on an old Toyota FD150. The name plate actually says "Toyoda Automatic Loom Works" on the bottom. The counterweight has "Toyota" cast in it. The engine is a straight 6 diesel natural asperated. There are 2 valve covers and the kill lever in the cab pulls on a lever that goes...
  5. 0

    Caterpillar Joystick Seals

    Just wanted to post this in case someone like me searched and could not find any more info than I did. Been working on a Caterpillar 236 B 3 skidsteer. Joysticks leaking from plungers on 7 of the 8. Cat either wanted me to buy 8 plunger kits for $125.00 or 2 new valve assemblies for $1000...
  6. 0

    Clark transmission help

    Is there anyone on here that can help with some Clark 28000 4spd transmission questions. Thanks
  7. 0

    Where can I get Fiatallis FR120.2 manuals

    Need wiring diagrams especially.
  8. 0

    JD 6068 in Magnum 235 - turbo replaced, ran good, then rough, now will not start.

    Symptoms when brought in: runs rough, black smoke, knocking (sounded like injector not bearings), code - turbo actuator not functioning or out of calibration (don't quote me on the wording of the code. Work done: Checked turbo impeller - loose but spin. Actuator would not move. Removed...
  9. 0

    JD 4045 w HPCR - wet fuel in all cylinder - will not run

    The exhaust ports are all about equally wet with fuel and soot. The exh pipe at the turbo had about 1/2" of wet soot in it - again I feel sure it is fuel. Injectors removed - no obvious damage. Turbo spin freely - could use a rebuild but I have seen worse slack and running fine. Everyone I...
  10. 0

    Magnum w/ JD 6068 - warning light - code 1180 inlet air temp?

    I have the problem noted in the title. Air flow is good. More than one of these generators doing this - this summer, but not last summer. Not to ask "leading questions", but where is this temp sensor that the inlet air temp on the controller shows 145F when I catch the code. Is it the sensor...
Top