• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Takeuchi TL130-Problems-Wont Move

A

A2Z

Member
Joined
Dec 16, 2018
Messages
8
Location
Florida
I unplugged the relay under the cluster everything seems to be working right i havent been able to drive it or try the funtions because its on a trailer bindered down anyone know what that relay controls?
 
A

A2Z

Member
Joined
Dec 16, 2018
Messages
8
Location
Florida
Yes the link expired hope it isnt the control box, i pull the meter fuse everything works fine but gauge box is dead machine works fine
 
A

A2Z

Member
Joined
Dec 16, 2018
Messages
8
Location
Florida
All my functions work but its stuck in high gear the buzzers on and all the lights are on if i unplug the high speed relay it is in low range. Ive tapped on all the relays it all stays the same i wish i knew what tge relays all did the descriptions are vague. Its like its stuck in first start check mode
 
S

skata

Senior Member
Joined
May 10, 2007
Messages
1,541
Location
midwest
A2Z said:
All my functions work but its stuck in high gear the buzzers on and all the lights are on if i unplug the high speed relay it is in low range. Ive tapped on all the relays it all stays the same i wish i knew what tge relays all did the descriptions are vague. Its like its stuck in first start check mode
Click to expand...
sounds like it could be something to do with the key? or follow the circuits from there.
 
Y

yohe41

Active Member
Joined
Nov 5, 2013
Messages
34
Location
apollo pa
Occupation
operating engineer/ owner
Ok everyone, I'm having same prob tl130 wont move, replaced proximity switch and both big and small relays still nothing, any suggestions PLEASE
 
S

skata

Senior Member
Joined
May 10, 2007
Messages
1,541
Location
midwest
If you search older posts on here, there is mention of a bypass plug located near the battery. This allows the machine to run but without safety gear active.
 
S

skata

Senior Member
Joined
May 10, 2007
Messages
1,541
Location
midwest
On my tl140 it sometimes won't move. I just tap on the relay cover in front of feet with a hammer and then it works. Lol
 
Y

yohe41

Active Member
Joined
Nov 5, 2013
Messages
34
Location
apollo pa
Occupation
operating engineer/ owner
skata said:
On my tl140 it sometimes won't move. I just tap on the relay cover in front of feet with a hammer and then it works. Lol
Click to expand...
We have been doing that too, lol but hasn't been working as well lately
 
heymccall

heymccall

Senior Member
Joined
Feb 19, 2007
Messages
5,379
Location
Western Pennsylvania
If tapping the relay panel helps, then, the relay boards need soldered. Only the triple relays come apart. If you see a Phillip's screw up they the bottom, it doesn't come apart.
 
Y

yohe41

Active Member
Joined
Nov 5, 2013
Messages
34
Location
apollo pa
Occupation
operating engineer/ owner
Ok new issues if I run the machine with the heat on full blast for about 30 mins machine functions normally any ideas
 
You must log in or register to reply here.
Top