• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by TD24

  1. T

    Clark C300-50 inching valve question

    Terrific job on the cleaning and restoration of the old girl. I recall the 2 # you ref on some old C50 Clarks, but do not recall having or using on the C300's. C300's are merely reproductions of the C model with a changed power steering system, alternator vs gen, and pedal connections. From...
  2. T

    Clark C300-50 inching valve question

    O K, Fluid is going by your U cup. In wrong or you did not clean you honing out well, (in 13 years we never had to hone one). Double springs are right (they default to push back when you release the inching brake, so you get a solid return). The other springs merely position the brass insert...
  3. T

    Clark C300-50 inching valve question

    Most likely the U cup is in backwards. You are applying pressure against it, not using it to pump down.
  4. T

    Help decode Yale GLC040 Model number

    I knew Tom Swift and dealt with him at Clarklift of Arkansas before he came out to the full Tom Swift. I bought over phone, and picked up at various other places . Tom was a good man to know, all his dealing with me were on the up and up. It was always just like he described it. Strange, I am 88...
  5. T

    Cat V40DSA Lost Forward need PDF

    As stated in the referenced quote: Just swap the feed wires and see if FWD starts and REV fails. Be your answer right there, the solenoids.
  6. T

    HYSTER 30 FORKLIFT; REPAIR INFO??

    HYSTER.stamped on top right side where counterweght meets frame.
  7. T

    Replacement forks sourcing CAT/JLG TL943 telehandler

    Suggestion.... Try these people. Said to be adaptable to the customers problems/situations. From your post, you might need a set of block/brick forks, modified as to mounting brackets and use more than two for capacity. Fork-Co 19113 Amoco Drive South Alvin TX 77511 United States 281-692-1667...
  8. T

    slow fork drop

    Glad it made a start. I would suggest you spray the lift chains with some cleaner to be sure they are free of kinks and flexing.
  9. T

    Clark C-500 Y30

    If still needed: Google Nash Forklift Supply, Nicholsville, KY. Get their website/address.phones. Contact them with your full model/SN and the mast number (off one of its rails). I recall the tilts vary with the mast heights (degree of tilt). If you can provide valid numbers, they can get you...
  10. T

    slow fork drop

    Pore thing is worn out...107 operating hours in 38 years, must have used it on three shifts, weekends and holidays... I jest... First simplicity: Do the chains lifting the carriage seem to be adjusted equally? Should be shortened enough to clear the forks 1/4" off floor, with mast vertical. If...
  11. T

    Mitsubishi 5k worehouse forklift

    Some of the arriving "equipment" might need some "lift" assistance to reach "top shelf". Just saying...
  12. T

    Mitsubishi 5k worehouse forklift

    I am recalling being told AW32 was equal consistency with 10W engine oil. That the ATF we used was DEXRON II. Been a long time since I poured any of it, so memory may be off. Suggestion.. What if you put it in full production use (Capacity loads/Fairly long runs) for say 30 minutes. Idea is...
  13. T

    Mitsubishi 5k worehouse forklift

    We always used AW32 in normal Sothern US temps in customers forklifts. Had a few in constant freezer operations and drained and used ATF. Worked in Clark, Yale, Cat, Baker, and some pallet jacks OK. You have cold, could be your present is too stiff...
  14. T

    Yale GC050RC Lift leaking brake fluid from Inching Valve on Transmission Control Valve

    Go to the link, open it and fill out the Make,(Yale) Model (GCO50RC), Gas, SN# (N429227)and it will give you : In stock, $18.38.... What's' to hope for?
  15. T

    Yale GC050RC Lift leaking brake fluid from Inching Valve on Transmission Control Valve

    Maybe like this? https://trupar.com/p/yale-forklift-inching-valve-kit-220003100
See more
Top