My hoe is inanimate!
I hoped to get firewood from the shed, move some generators, move driveway sand to the garage before snow tonight.
Yesterday, I started it. The engine has a grid heater in the intake. After a few seconds of that, it started instantly. I let it warm up at 1000 RPM, & moved some other vehicles.
Ten minutes later an alarm was going off. The Stop sign displayed on the instrument panel. A symbol with a crankcase, above a wedge, an arrow down the ramp.
I've searched service & operator's manuals, can't find that symbol. Seth thinks Too low RPM.
Today there are 13 codes.
Hydraulic filter blocked.
Unknown Error
Water sensor check failed. This part has been ordered since September.
Fuel Metering unit; #1 injector pressure too high.
Another Fuel Metering.
Oil pressure sensor fault. Not to be confused with low oil pressure.
Fuel sending unit, Also back ordered since September.
Water in fuel, See above failed water sensor.
Charge pressure switch closed, no frequency input to trax connector.
Others old faults related to shift problems now seemingly resolved.
This is a 2014 Case 580 Super N. It's pre DEF.
I've had four other older backhoes over the years, nothing this complicated!