So I'm in the process of getting things together to rebuild the undercarriage, a few questions
I think I can handle most of it, seems pretty straight forward except.......
The rear sprocket, debating on replacing the whole thing or just the maybe outer section. Have seen where you can buy the toothed section. I can cut and weld so that doesn't concern me, what does is that it's already been done on mine, not sure if it should or can be done again, any consensus????
I would prefer to just replace the whole thing, the price isn't an issue, I have a complete service manual and it talks about using a hydraulic puller to remove it and a hydraulic ram to re-install it....can it be done with out the use of the hydraulic puller and ram????
That would be the main stumbling block in replacing the whole sprocket
Thanks for any input
Tom
I think I can handle most of it, seems pretty straight forward except.......
The rear sprocket, debating on replacing the whole thing or just the maybe outer section. Have seen where you can buy the toothed section. I can cut and weld so that doesn't concern me, what does is that it's already been done on mine, not sure if it should or can be done again, any consensus????
I would prefer to just replace the whole thing, the price isn't an issue, I have a complete service manual and it talks about using a hydraulic puller to remove it and a hydraulic ram to re-install it....can it be done with out the use of the hydraulic puller and ram????
That would be the main stumbling block in replacing the whole sprocket
Thanks for any input
Tom