Every time i flip a piece with any sort of weight on the overhead it always puckers my bottom side.
I see the rod oven are you guys stick welding all these beds out? Is there a reason that your not using wire feeders with either dual shield or self shielded FCAW?
I take it the beds are full pen welded at the seams, flipped over back ground and welded out?
I see the rod oven are you guys stick welding all these beds out? Is there a reason that your not using wire feeders with either dual shield or self shielded FCAW?
I take it the beds are full pen welded at the seams, flipped over back ground and welded out?