Reuben
Senior Member
I am going to post this with as many facts as possible to help with answers...........I was digging out for a bridge abutment with our JD 200D on a job I am doing. I was switching back and forth between the hammer and the bucket several times today and a few times after getting back in the machine the controls didnt work after engaging the lock out lever. I would either have to just flip the lever again or shut it down and restart it. I also noticed that the "rabbit" speed on the tracks quit working also. I had the hammer on and I was out in the middle of the road and I hopped out to move a traffic deliniator and when I got back in none of the controls will work at all no matter what i do. I checked all the fuses, wiggled wires,messed with different work modes on the display and nothing!!! The switch seems to be working in the lock out lever because it will not start is the lever is down as always. but when the lever is up it still starts just as it should.It is basically a new machine,it only has 600 hours on it. IT is 7:20 pm on friday and the machine is still on the road and the deere mech is not coming till morning. Any suggestions would be a huge help.Not only do
i want the machine off the road I would like to get my abutment dug out tomorrow.
i want the machine off the road I would like to get my abutment dug out tomorrow.