Hello there.
just bought a 1995 Deere 490E from nephew of a guy that died of COVID so don't know much about the machine.
nephew is telling me it needs a "hydraulic computer"
behind the seat there are two computers.
the computer on "top" is blinking, sequence is ...5235734523573... which just repeats (don't know which number is first)
the "lower computer" there are no lights blinking. because he told me the bottom computer was the fault, I purchased and replaced but still the same problem... and new computer (bottom computer) still no lights.
--> starts and runs fine, can crawl, but engine stalls when using boom, stick, bucket, unless its in "P" mode and even then it stalls especially with the stick outstretched at all and moving bucket..
not sure which computer is which, but is the problem with the top computer given that it is flashing?
any resources on any of this anyone knows about or where to start to try to diagnose this ?
thanks !!
just bought a 1995 Deere 490E from nephew of a guy that died of COVID so don't know much about the machine.
nephew is telling me it needs a "hydraulic computer"
behind the seat there are two computers.
the computer on "top" is blinking, sequence is ...5235734523573... which just repeats (don't know which number is first)
the "lower computer" there are no lights blinking. because he told me the bottom computer was the fault, I purchased and replaced but still the same problem... and new computer (bottom computer) still no lights.
--> starts and runs fine, can crawl, but engine stalls when using boom, stick, bucket, unless its in "P" mode and even then it stalls especially with the stick outstretched at all and moving bucket..
not sure which computer is which, but is the problem with the top computer given that it is flashing?
any resources on any of this anyone knows about or where to start to try to diagnose this ?
thanks !!