Hello all,
I have been struggling for a week trying to get my skid steer back into operation.
Backstory is I got stuck out of state for two months and the skid got infested with mice.
I have a 9406 code on the tr340. I have taken apart the whole cab to expose wires and I replaced two under the seat that I could reach. Is it possible this code is from other wires under the seat?
I have tried to jump the power and eh module to no success. It still prompts me to start when I sit on the seat and runs fine (aside from no hydraulic controls working)
I realize at this point I probably have to tilt the cab. I think I am going to buy a gentry crane from HF to do this since I don’t have an excavator or other heavy equipment that can reach it.
For the TR340 in a ‘15 flavor will the arm raise if the emergency down button is held or do I have to remove the hydraulic line most likely?
Thank you very much. This has been a frustrating experience. Last year I had a major hydraulic line bust and got a bill for 3k from the dealer so I really really don’t want to use them again.
Erik
I have been struggling for a week trying to get my skid steer back into operation.
Backstory is I got stuck out of state for two months and the skid got infested with mice.
I have a 9406 code on the tr340. I have taken apart the whole cab to expose wires and I replaced two under the seat that I could reach. Is it possible this code is from other wires under the seat?
I have tried to jump the power and eh module to no success. It still prompts me to start when I sit on the seat and runs fine (aside from no hydraulic controls working)
I realize at this point I probably have to tilt the cab. I think I am going to buy a gentry crane from HF to do this since I don’t have an excavator or other heavy equipment that can reach it.
For the TR340 in a ‘15 flavor will the arm raise if the emergency down button is held or do I have to remove the hydraulic line most likely?
Thank you very much. This has been a frustrating experience. Last year I had a major hydraulic line bust and got a bill for 3k from the dealer so I really really don’t want to use them again.
Erik