rmllarue91
Senior Member
3ml365 machine had lots of electrical and hydraulic issues got most straighten out but it's acting like it won't save calibration. Machine is super slow in auto. If you switch to manual slow mode it's a little faster than auto. If your in calibration sub mode machine will respond to changing the two vaules but if you shut machine off or hold service key it goes back to super slow. I didn't have book with me and couldn't remember how to see if there's codes. I ordered a new prv valve. I will install check codes and try to recalibrate but was looking for some experience with this. Also if someone has experience with adjusting pumps i could use some pointers. I currently don't have a differential pressure gauge or large enough flow meter so I'm not sure how much I can do on this with just pressure gauges. Thanks hef