• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

transmission issues

  1. B

    Case wheel loader 4 th gear problem

    Hey Everyone, I have a 2011 721f case wheel loader. First second and third gears work fine but as soon as i shift into 4th gear it sends the transmission back into 2nd or third gear abruptly and it doesn’t matter if the loader is stationary or mobile. Any suggestions would be greatly...
    • Bignewf
    • Thread
    • 2011 4th gear case 721f transmission issues wheel loader
    • Replies: 4
    • Forum: Wheel Loaders
  2. Y

    980G Transmission Pump Pressure Low When Machine In Motion After Speed Change

    Hye all Details per below: Model: 980G Machine SN: AYT249 Engine SN: BET5197 Reported when on auto shift, after changing speed from 1 to 2, then 2 to 3 and so on, the machine speed did not increase. Suspected the clutch disc slipping and was confirmed since we can smell the burnt oil once...
    • YulMY
    • Thread
    • 980g transmission cat loader transmission fault transmission issues
    • Replies: 7
    • Forum: Wheel Loaders
  3. J

    1996 John Deere 544G transmission issues

    So recently bought a 1996 John Deere 544G with the 4 speed transmission ( 1,2,3, and D). Anyway, when going from neutral to forward or reverse it clunks hard once as it shifts and then drives and runs fine, it clunks again as you shift from first to second to third to drive, no matter what gear...
  4. G

    Gehl DL6L shift issues

    I have a gehl dl6l-42 that started not shifting into 3rd and 4th gears. I can switch between 1 and 2 and works fine but when I shift up to 3 the transmission does not shift. The electric monitor displays the correct gear that shifter is in.
  5. Ivan Adiego

    Carraro TLB1 4WD noise and hard to shift

    Hi, I'm a new member on the forum. I've been reading some of the related threads, searched online and downloaded some manuals but still not really sure what is going on. I bought a used 2012 TEREX 760b backhoe with 2300 hours a couple of months ago, It came with a synchro shuttle transmission...
    • Ivan Adiego
    • Thread
    • carraro carraro tlb1 noise shifting problem terex 760 transmission issues transmission problems
    • Replies: 19
    • Forum: Tractor/Loader/Backhoes
  6. 1

    1450B no steering

    I have an older Case 1450B machine that I rented out to a guy to use around his acreage. He checks the engine oil, coolant and transmission oil levels every morning before use. In the morning, all fluid levels were fine. He contacted me around noon yesterday and said he lost steering and the...
    • 1450B
    • Thread
    • 1450b case transmission issues
    • Replies: 17
    • Forum: Dozers
  7. D

    434E Hydraulics Problem

    I picked up a used 434E a few months ago. It ran great until recently. It was at a job site when all the hydraulics became very slow. Also the travel home was very slow. The engine reaches proper rpm, fluid levels and filters ok. Anyone have an idea what to look for? Is there some ECM...
  8. D

    Allis Chalmers 545B transmission

    I just replaced my TT 2221-1 Allison transmission in my wheel loader and cannot seem to get the charge pump to pick up the fluid. I put in 15/40 to start and have tried 3 (used) pumps that I have. I have put a hand crank pump to the draw tube to check if there were any leaks in the tube. I was...
    • Douglas 545B
    • Thread
    • allis chalmers transmission issues wheel loader transmission
    • Replies: 0
    • Forum: Wheel Loaders
  9. G

    Champion 750 trans. help needed

    Thinking of buying local 750 champion but the transmission has little to no reverse. It will backup on hard level ground in 1st gear but only at an idle, must be very gentle. The other 3 reverse gears do nothing. All forward gears seem to work good. Anyone have any ideas, solutions?
  10. S

    Deere 310sj lost 1st gear

    i have a 310sj with 3000hrs. It has the power shift transmission. Tag says is a zf 4wg94. The transmission lost 1st and 3rd gear all at once. it Has no error codes. Oil level is full. I put a gauge on port k1. It has less than 10 psi. I put gauge on k2 for second gear and I have 260+- while in...
  11. B

    JD310 SE Tranmission - After heavy use will slip out of gear or not engage

    Hi, I've put in about 25 hours since purchasing this JD and for most use, in close areas, I have no issue going into FWD and REV. On Friday and yesterday I've been moving crushed rock to another area of my property (about 1/4 mile drive) and the issue will appear. Normally I'm in 1st gear and...
  12. B

    D4D powershift

    I’m having issues with my D4d dozer, not sure on the year model I’m thinking late 60s early 70s. Serial is 83j839, 1st gear fwd, and rev always work good. Second gear forward and reverse it will pull its self when cold but will not push dirt. And barely loads the engine. When transmission warms...
    • BradleySherrell
    • Thread
    • cat d4d dozer powershift transmission issues
    • Replies: 54
    • Forum: Dozers
  13. A

    CAT 130G 9Y Series Transmission Won't Shift

    Hello all, I've got a 1978 CAT 130G 9Y series grader with the 3304 engine that will not shift into either forward or reverse at any speed. Main Hydraulics work fine. So far I have checked: Transmission Oil - Full Transmission Filter - Replaced Transmission pump pressure - low 250 PSI, added...
    • andy.jobcorps
    • Thread
    • cat 130g grader motor grader shifting problem transmission fault transmission issues transmission problems
    • Replies: 13
    • Forum: Motor Graders
  14. C

    Timberjack 360 pops into neutral

    Hey guys been thru here a couple times browsing the internet looking for pointers, all here seem quite helpful. Been working on equipment for a while, this ones got me stumped. Did a search cant find anything quite exact to what this machine is going thru. Got a Timberjack 360 cable. Cummins...
  15. S

    1991 dresser 510C weak reverse

    Recently rebuilt the 4bt engine reinstalled it started using it found with a load or on any incline at all the loader will not move. Forward gears are all ok any troubleshooting available? Just replaced trans filter,trans oil and cleaned trans sump screen. Any help would be appreciated thanks.
    • shifty22
    • Thread
    • 510c dresser international dresser transmission issues
    • Replies: 0
    • Forum: Wheel Loaders
Top