• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

loader

  1. C

    980K Transmission Cooler Bracket

    Hey Everyone, Has anyone had any experience with 980K transmission cooler bracket bolt failures? My customer has a fleet of 980K’s and I have repeatedly seen this failure. The failure being the bolts for the transmission cooler bracket end up breaking off in the engine block, which then causes...
  2. S

    Dresser 520C Trans Needed!

    Hello all, I am purchasing a 1994 Dresser 520C I want to pick up a transmission for it. I have attached a photo of the information on the front of the trans. Any help on locating one would be appreciated. Thanks all, MJ
  3. Jake Erickson

    821 Case Payloader transmission

    I’ve got an 821 (plain) loader. Had 1st gear solenoid go out twice on it in the past. Today while working 1,2,3 gears quit working. Drove it to the shop and when I got there they all worked again. It was intermittent so I parked it, I’m almost certain it’s electrical causing the solenoids to...
  4. M

    WA250PZ-6 Won’t go into first

    I have a WA250PZ that currently won’t go into first. 2,3 and 4 are all working fine. When I put the variable control into 1st it’ll show first in the dash but still only operate as low as 2nd. New to diagnosing these issues and would love some help or guidance. I was maybe thinking a bad...
  5. K

    Antique Case Hydraulic Pump Upgrade

    Hello everyone, Looking for those who are more experience with this sort of thing than I am. My 1963 Case 530 Loader/Backhoe just pushed the seal out of the hydraulic pump: typically a strong indication of a worn out pump as I understand it. Can anybody verify that? Now of course this pump was...
  6. J

    FIAT ALLIS FL14B driving on one side only

    Hello all, searching for some help narrowing down a steering/ drive issue with fiat allis fl14b loader. The issue is the left track works flawless, drive,clutch,brake. The right track has no drive at all, brake works fine. So here's what I have done, taken the clutch valve body completely apart...
    • Jdkellerman
    • Thread
    • crawler final drive fl14 loader
    • Replies: 14
    • Forum: Dozers
  7. V

    wheel loader or loader backhoe??

    Hi all, I kind of have my mind made up but feedback and advice is always welcome. I own a 1996 JD 310D backhoe. I purchased it 15 years ago when it had 4600 hours on the meter. It now has almost 15,000. It has been an amazing machine that owes me nothing. it still works every day although...
  8. A

    t595 loosing and regaining hydraulic function

    Hello, I have a 2016 t595 that I purchased to use around the farm. It was recently serviced by bobcat and has been running great. A few days ago, I topped off the hydraulic oil, just under the red line. I went to use it today, engine starts just fine, I press the green button, turn the throttle...
  9. J

    JD 324 Loader 3rd & 4th Function

    I have a 2019 John Deere 324 Loader that is primarily used for snow removal. It works with a metal pless plow for the majority of its hours. I am trying to get the joystick control (3rd & 4th function) to both work to control the blade. I currently have the 3rd function as the hydraulic...
    • JeremyH
    • Thread
    • 324 jd 324 john deere loader metal pless snow plow
    • Replies: 3
    • Forum: Wheel Loaders
  10. Newbury1289

    JD 544k overheating

    I have a 2018 JD 544k with 777 HR the problem I am having is the cooling fan is not working properly, the fan is running at 200rpm at 100% command, and about 500 rpm at wide open throttle, I tested for power at solenoid I have 26v when running, and tested solenoid, this machine does not have...
  11. RightTrack

    TEREX IBH 7251 Salvage yard?

    I think I have a Terex 7251 AA (the serial tag does not have a model number) (S/N 55167) and I was wondering if anyone knew where I could find a steering Gearbox for it. I've tried searching for salvage yards that might have one sitting around, but I had no luck. I'm almost leaning towards...
  12. T

    Cat 950k auto level, bucket curl issue

    The company I work for has a 2013 950k loader. They recently replaced the loader arms, opting for a used pair. When they re assembled the machine and brought it back to the pit the bucket would not fully curl all the way back, instead it sits at almost 80% curled when attempting to retract it...
  13. R

    780CK Case Backhoe- maintenance/T.S.

    New member here! I recently purchased a new to me 780 case backhoe, Last running in february, Once purchased I was told that they installed a new fuel injector system, I had to install the turbo, thread on the fuel rails, new gaskets on the intake manifold to the radiator, and then add the...
  14. A

    Tractor & Loader Manuals PDF

    Hi. I found two interesting sites there you can find a lot tractor, dozer, loader, excavator PDF manuals, electric wiring diagrams, fault codes dtc: https://tractormanualz.com/ and https://www.tractormanualpdf.info/ Enjoy
  15. M

    Kubota R530 - Center Pivot/Bearing Concern

    Hello, New to the thread so my apologies if this has been covered many times, i did a quick search and did not find anything exact however. We have a "New-to-me" R530 Machine that we use at our sawmill and lumberyard mostly with forks for hauling logs and moving stacks of lumber. Great machine...
    • m2lumber
    • Thread
    • bearing center pin kubota loader pivot r530
    • Replies: 3
    • Forum: Wheel Loaders
  16. J

    Michigan 75A Wheel Loader

    I have just purchased a Michigan wheel loader and it is in fair shape, everything works but the brakes, and it does not want to move when you first start it up and try to move, after you warm it up and keep the throttle high it goes in gear and works fine in all gears, no slipping, however if...
  17. YellowIronSam

    Diggers and loaders in Italian marble quarry

  18. J

    John Deere 244j air condition not working

    I have a John Deere 244j and the air conditioning isn’t engaging. Compressor clutch isn’t turning on. Tested all the fuses to find them all good. Tested the relay to find that there are 5 pins on this relay. The top two larger pins, switched side, doesn’t ever have power, the other larger pin...
    • JeremyH
    • Thread
    • air conditioning electrical diagnostics electrical problems john deere john deere 244j loader wiring diagram
    • Replies: 5
    • Forum: Tractor/Loader/Backhoes
  19. D

    can't get arms to raise up on my CAT skid steer

    i have a CAT skid steer model 232b2. i haven't been able to get the arms to raise up on it. with machine running parking indicator lamp does not come on. when i am pushing the button to release the parking brake, the seat belt indicator light starts flashing. machine will move, but i cannot...
    • dondd222
    • Thread
    • arms cat caterpiller loader skid steer
    • Replies: 1
    • Forum: Skid Steers
  20. Tom Sticpewich

    Volvo L90E harsh shifting

    Hi guys. I have a Volvo L90E here which has harsh shifting between gears especially 1st - 2nd I have a manual I down loaded but the procedure for check the pressures is a bit light on for details and it has no specs. but I managed to check the main pressure and I got 275psi then I checked lube...
Top