• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    No response from emergency dial will double check pilot pressure but don’t think it was building anything
  2. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    Also you can pull the fuse for the mechatro controller and it will load the hydraulics while cranking engine
  3. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    I do have hino dx with the adapter. I was using the autel 908cv with hino software. Engine runs fine no miss but the ecm doesn’t see the throttle input form the mechatro controller. I can see the throttle change on the gauge cluster in the diagnostic mode. New to the heavy equipment stuff...
  4. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    Yes 24v battery cables clean and tight. Checked the 4 of the 6 grounding points so far.
  5. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    Yes it is all the way to the left. Haven’t fount a kpss switch yet I’ll look through the manual and see if it mentions it I haven’t seen a kpss switch on it yet. I’ll look through the manual and see if it mentions it.
  6. Kaden134

    Kobelco sk350lc-9e mechatro issue?

  7. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    Yes sir it does it sees the throttle percentage. Changes with dial I also tried in the normal position.To my knowledge the switch has always been in the released position. The switch I’m referring to is by the fuse box to the right of the throttle dial it’s for the swing brake release. Emergency...
  8. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    They unloaded it parked it came back a few days later unit will start but no throttle no hydraulics kpss switch is in the release lock position also tried normal no change had a nox sensor code from a previous issue but has been resolved
  9. Kaden134

    Kobelco sk350lc-9e mechatro issue?

    Got a kobelco sk340lc-9e I think I may be having some issues with the mechatro controller no fault codes on the cluster. No active fault codes in ecm But I have no throttle and no hydraulics I can throttle the engine to about 1000 rpm with my scan tool but not any higher. Safety switch/ lever...
Top