MKMmech
Member
Good day all! Newbie to the forum
I’ve got a Genie z45/25
S/N z452506-28022.
This this is making me pull my hair out a bit.
All functions work but drive won’t work, I’ve calibrated joystick, also tried another joystick and still no luck.
I’ve noticed some corrosion on the pins at the ALC500 in platform control so I replaced the pins.
I tried the unit yesterday after it sat for a while then it moved about a foot and stopped, tried again either direction and nothing
All sections are in stowed position,
I replaced the turet/rotate switch as it was badly corroded.
Also replaced the ALC500 but that did not fix the issue.
Any help would be greatly appreciated
I’ve got a Genie z45/25
S/N z452506-28022.
This this is making me pull my hair out a bit.
All functions work but drive won’t work, I’ve calibrated joystick, also tried another joystick and still no luck.
I’ve noticed some corrosion on the pins at the ALC500 in platform control so I replaced the pins.
I tried the unit yesterday after it sat for a while then it moved about a foot and stopped, tried again either direction and nothing
All sections are in stowed position,
I replaced the turet/rotate switch as it was badly corroded.
Also replaced the ALC500 but that did not fix the issue.
Any help would be greatly appreciated