• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Tudur DAvies

  1. T

    Volvo EC210C Engine Problem

    Thanks, do you have the correct torque settings as well. Believe it is step 1: 30Nm, Step 2;: 80Nm, Step3: 90 degrees. But would like to double check. Thanks
  2. T

    Volvo EC210C Engine Problem

    Hi, Struggling to find head bolt tightening torque and sequence if anyone can help? Thanks
  3. T

    Volvo EC210C Engine Problem

    Hi, Had the injectors, oil cooler and head test results back. Injectors ok, oil cooler ok, head warped at cylinder no6. Current thinking is that engine was switched off when hot (had been working hard), head warped causing major leak at gasket. Possibly no visual signs of damage as engine only...
  4. T

    Volvo EC210C Engine Problem

    Hi, Would anyone know what is included in the Volvo 'cylinder head kit'? Part number VOE15011854. Dealer aren't able to provide a breakdown of kit content. Does it include all gaskets and seals from bottom of head up? Exhaust manifold gaskets etc? And does it include replacement head bolts? Thanks
  5. T

    Volvo EC210C Engine Problem

    Main reason for suspecting injectors is large volume of diesel in engine oil. Engine started, was switched off after approx 20 seconds after noticing white smoke. Locked up during cranking approx 5 mins later. Head gasket and liners look good. Engine turned easily by hand after removing head...
  6. T

    Volvo EC210C Engine Problem

    Hi, Suspected injector failure on 2007 EC210C resulting in fuel in the oil, white smoke followed by engine hydrolocking on turn over. Signs of engine oil in the coolant as well, so head has been removed to be tested along with injectors. Head, gasket and liners all seemed good in visual...
  7. T

    Volvo EC210C Fuel Problem

    Hi, Had a look at the sensor readings, fuel pressure stays at 7bar whether engine is running or not, I took the sensor out of the housing and it still read 7 bar. When disconnecting the sensor connector, pressure drops on screen to around 3 bar. Could be sensor or wiring problem? Also boost...
  8. T

    Volvo EC210C Fuel Problem

    Hi, Checked filters and drained bottom of tank, fuel very clean. Filters were replaced around 20 working hours ago, had been running fine until the fuel pipe leak. The following error code comes up every time SID232-04, any ideas what this code is? Machine will run (underpowered) for around...
  9. T

    Volvo EC210C Fuel Problem

    Hi, Recently had a fuel pipe leak (part no VOE20838200) on a Volvo EC210C which caused the engine to stop and show error code SID232-04. Replaced pipe and engine is still sometimes throwing error code SID232-04 and will stop itself. The pipe was a double headed pipe which I believe feeds fuel...
  10. T

    Volvo EC210c power to worklights

    Hi, Struggling to get power to the worklight system on a Volvo EC210c. All the fuses in the main fuse box behind the cab are fine. Is there a separate set of relays or fuse for the lights somewhere else on the machine? No power coming to the light switches in the cab either. Everything else...
See more
Top