1968 Case 580CK
Senior Member
I was wondering why Case failed to put grease fittings on the two rear pivot points (as seen in these pics) of the front end loader. Before painting, I decided to remove the bolt so I could clean and pack fresh grease inside. I greased the bolt, but there is another sleeve that actually rotates which you cannot grease without removing the entire arm. So, I managed to spray lube and oil around the sleeve.....better than nothing I suppose. So, why not have grease fittings back here?
![Case Restoration May 2015 207.jpg Case Restoration May 2015 207.jpg](https://www.heavyequipmentforums.com/data/attachments/122/122430-53baa835e019cff07686799a04088075.jpg)
![Case Restoration May 2015 212.jpg Case Restoration May 2015 212.jpg](https://www.heavyequipmentforums.com/data/attachments/122/122431-0f3c0ae5dcdc8e6c040209be5d11d058.jpg)
![Case Restoration May 2015 207.jpg Case Restoration May 2015 207.jpg](https://www.heavyequipmentforums.com/data/attachments/122/122430-53baa835e019cff07686799a04088075.jpg)
![Case Restoration May 2015 212.jpg Case Restoration May 2015 212.jpg](https://www.heavyequipmentforums.com/data/attachments/122/122431-0f3c0ae5dcdc8e6c040209be5d11d058.jpg)