Can't figure out why my boom won't go up all the way, boom is all the way to the right can hear hydraulics cut out, I tested the wires to underneath the cab all have continuity, fuse is good. I'm not sure how to test those 3 sensors though? Could I swap them? It doesn't matter which bucket I select it raises to the same point I can cycle back and forth 10 times no difference. It goes up to where it would hit the cab if it was to the left so the interference is working somewhat.
Also the auto decel, doesn't and has never worked, other then fuses i'm not even sure where to start?
If tracks are up in the air 2 speed will work, but if on the ground it will instantly kick out, light comes on/off with switch. I believe from what I found so far is there is a solenoid by the pump, the other one is for the arm lockout? (which doesn't work either).
Also the auto decel, doesn't and has never worked, other then fuses i'm not even sure where to start?
If tracks are up in the air 2 speed will work, but if on the ground it will instantly kick out, light comes on/off with switch. I believe from what I found so far is there is a solenoid by the pump, the other one is for the arm lockout? (which doesn't work either).