Picked up a hammer for my 210 I figured for the odd small job but mostly to put a plate on for packing. But I got offered to quote a large demo, around 80,000 sq/ft of precast concrete mostly 8" thick. I am wondering if I run a hammer for this big of a job how bad is it going to be for the machine? Should I? I was ballparking pricing it at an additional $150/hr for running a hammer. I'm concerned being the machine has 9,000 hours and is really tight, is say 100 hours of hammering going to do a lot to the pins and hoses to make me regret it? It's a smaller hammer for the machine, only 2200lbs.