Hi,
does anybody know if it is possible to fine tune the behavior of the hydraulics by editing some parameters on the A4M1 ECM of a D6 using the CAT ET tool ? Hydraulics are moving too quickly when sending the minimum CAN valve drive message (1 out of 255). Help & information would be greatly appreciated.
Thanks
does anybody know if it is possible to fine tune the behavior of the hydraulics by editing some parameters on the A4M1 ECM of a D6 using the CAT ET tool ? Hydraulics are moving too quickly when sending the minimum CAN valve drive message (1 out of 255). Help & information would be greatly appreciated.
Thanks