dennis sanders
Well-Known Member
Blade functions normal except left angle.....have to pull lever up and left to get it to work.....
NO, check the control linkage before wasting time with stuff like this. A full 30 percent of my service calls are related to worn control linkage.Pull the pins on both your angle cylinders and then try the angle function. It may be one of your angle cylinder has had the nut come loose.
Trans filter is under the floorboard. the top has 6 half inch bolts holding it on. It's a cartridge type, not a spin on.I can't locate the transmission filter....surely don't have to drop the pan...any help is appreciated.
Ah yes... Critters. I once had a D6M that would not move. Frikken rabbits ate the transmission control harness. It had only been sitting over the weekend.It will angle....just slow...I'm thinking something has gotten in the lever pivot....takes both hands to twist to the left...have to pull back and twist to get it to angle...like its jammed.....yrs back had a steering lever in a450c Deere act the same way...pulled the floor cover .....found a black snake wrapped up around it...