D6K2 with CAT Accugrade or 700K with Topcon 3DMC squared machine control?
Anyone have direct knowledge comparing a D6K2 with CAT Accugrade versus a 700K with Topcon 3DMC squared?
We're trading a higher hour 700H which we used with a Topcon base and rover and a Agtek/Xybernaut indicate system. No complaints with the 700H but need a more efficient finishing combo for parking lots, ball fields, parks, etc.
We're trying both right now. Accugrade seems that it may lose either radio connection or GPS signal quicker than the Topcon. Topcon seems to take 5' to figure out where it is when changing directions where Accugrade seems a little quicker.
Suggestions either way?
Anyone have direct knowledge comparing a D6K2 with CAT Accugrade versus a 700K with Topcon 3DMC squared?
We're trading a higher hour 700H which we used with a Topcon base and rover and a Agtek/Xybernaut indicate system. No complaints with the 700H but need a more efficient finishing combo for parking lots, ball fields, parks, etc.
We're trying both right now. Accugrade seems that it may lose either radio connection or GPS signal quicker than the Topcon. Topcon seems to take 5' to figure out where it is when changing directions where Accugrade seems a little quicker.
Suggestions either way?