steve waldner
Well-Known Member
I have this 2012 360-10 10k hrs
New sprocket and rails (oem) but the tracks walk back and forth 2 “ when working , it drives me nuts . Had the planetaries apart and completed the insides to new parts , hardly a difference if any . Is it possible the motor brake is not grabbing right and it uses hydraulic oil of the motor to brake the drive ? Both seam the same . The sun gears are tight . The other gear set connects to motor with shaft , so if motor would brake the outer gear should not move . Unless there is a lot of slop , but we compared the inside parts to brand new ones we ordered , just to compare , no difference . Would love a little advice . It has gotten worse over the last couple years . I can post a video if u want me too . Thank you
New sprocket and rails (oem) but the tracks walk back and forth 2 “ when working , it drives me nuts . Had the planetaries apart and completed the insides to new parts , hardly a difference if any . Is it possible the motor brake is not grabbing right and it uses hydraulic oil of the motor to brake the drive ? Both seam the same . The sun gears are tight . The other gear set connects to motor with shaft , so if motor would brake the outer gear should not move . Unless there is a lot of slop , but we compared the inside parts to brand new ones we ordered , just to compare , no difference . Would love a little advice . It has gotten worse over the last couple years . I can post a video if u want me too . Thank you