dieselfuelonly
Member
Hey ya'll, I made three posts so now I can finally start a thread and hopefully get some help.
I have a 2000 Bobcat 753, and I'm currently rebuilding the control valve on it.
I bought a service manual and followed the procedures in it and removed the entire control valve/BICS valve assembly. What a pain.
My machine was very dirty on the inside and was impossible to clean everything off when I removed the control valve - so I'm worried that if I don't clean out the control valve blocks, that there is some mud, grit, etc. that might have fallen into the passages that will undo all the work I'm doing to rebuild it.
I need some ideas on how to clean the passages out to make sure that they are very clean when I put the parts back together.
If anyone would be willing to share some ideas or suggestions it would be greatly appreciated. Thanks.
Here are a couple pictures.
_____
Dennis
I have a 2000 Bobcat 753, and I'm currently rebuilding the control valve on it.
I bought a service manual and followed the procedures in it and removed the entire control valve/BICS valve assembly. What a pain.
My machine was very dirty on the inside and was impossible to clean everything off when I removed the control valve - so I'm worried that if I don't clean out the control valve blocks, that there is some mud, grit, etc. that might have fallen into the passages that will undo all the work I'm doing to rebuild it.
I need some ideas on how to clean the passages out to make sure that they are very clean when I put the parts back together.
If anyone would be willing to share some ideas or suggestions it would be greatly appreciated. Thanks.
Here are a couple pictures.
_____
Dennis
Last edited: