Mitsubishi MRX 35

[2112]

Yep,

I was told This mini and the Hanix S&B20, Or Kubota KH30SR are the same (all made by Mitsubishi I am told). I think all Gray Market tho.

I will try PAPE' in Tacoma tomorrow and see what they say. Appreciate the offer of help. If necessary, I can take Hi-Res pics.

 

[2112]

The Adjusters were polished and cleaned and new seals placed. The wheels will be a wintertime project as now I would want to wrap a few projects up.

Tracks are on and it moves nicely. Thanks for all the suggestions.

 

[dirtmonkey]

This is off topic but welcome my fellow RUSH fan ! That is still my favorite record. :notworthy

 

[2112]

This is off topic but welcome my fellow RUSH fan ! That is still my favorite record. :notworthy

Yep, soundtrack to my life;

http://www.rush.com/albums/

 

[BullFrogNC]

2112.....from your posts above you have some good schematics for your MXR35. Are these available somewhere that I can purchase? I'm looking replacement parts for my MXR35 and it would be great to have the part #. I need the "swivel-joint" stud that holds the lever to the frame. Will try to post photo but I am new at this. Thanks for any response! (RUSH fan here also!)

 

[BullFrogNC]

Don't know if these 2 photos will show properly but here goes!

 

[2112]

The Guy I bought the machine from in Oklahoma e-mailed those to me.

It was like pulling teeth to get those, unfortunately that is all I had.

Machine has run great for a couple years now.

A helpful caterpillar (since they sell Mitsubishi) dealer might be able to help you. Emphasis on helpful. These Grey Market machines are brutal finding parts for. Is there a boneyard out there maybe??

 

[BullFrogNC]

Thanks 2112.........I have been searching for source of parts and/or schematics for over a year.

Machine works great until couple of weeks ago when this stud broke. I will take it to a good expert welder that I know.....see if he can weld bolt to it. Small size is the issue.

:idea.......Weld a LARGER bolt to it & just enlarge the hole in the frame! Problem solved! Thanks again for your reply!