Just did my second front diff repair on this series 2. New clutch disc assembly with side gears and shafts. Did assembly and clearance spec was good. Soaked friction discs over a weekend. Put it back together and installed in housing. Completed and ran it out the shop. Seems fine going forward but starts acting up turning left. (Popping sound). When turning right it just seems like it’s tight. Removed rear drive shaft and put front wheels in the air. Front spins in gear fine. Brought it back in and took it back apart. No damage besides a few scars on a couple side gears. Put it back together and the clearance is a little off.
spec is .20mm and I got .30ish
I know that the clearance is more but...
If you have some experience with this is this issue a loose issue or would it be more if it was tight.
Just trying to learn.
The first one I did I did this the same way with no issues.
if it matters...
Service tech at a construction company.
thanks
spec is .20mm and I got .30ish
I know that the clearance is more but...
If you have some experience with this is this issue a loose issue or would it be more if it was tight.
Just trying to learn.
The first one I did I did this the same way with no issues.
if it matters...
Service tech at a construction company.
thanks