Kobelco ireland
Senior Member
You should be able to get the harness in sections, engine and pump harness can be got separate to cab harness. Last time I got engine and pump harness for a 2006 210 it was around 2000 euros
There will be oil inside that cover only a few litres. When cover is off remove the small gear at the centre and the drive will free wheel. Refit the cover to keep inside of drive clean when movingOK....questions about moving this machine.
Ok.....to take the sprockets out of service, simply removed the cover opposite the drive motor(s) and take all the bolts out that mate the sprocket to the rest of the workings of the drive motor and everything. I have looked through the manual briefly, and the details aren't there. I supposed that's because a trained monkey could do that. There is a cover (round) as the very outside component covering the drive mechanism. The actual motor is "inboard", so won't be touched. Question: Once the cover bolts are removed, will this be full of oil or anything? R
You should be able to get the harness in sections, engine and pump harness can be got separate to cab harness. Last time I got engine and pump harness for a 2006 210 it was around 2000 euros
Would backing off the cross port relief valves on the motor allow it to swing?The slew motor in that machine won't freewheel after you release the brake. You will have to remove the two feed pipes that are located just above the pipe for releasing the slew brake. It will only loose a half litre of oil even when you push it around