John deere 319e remote start no working.

[Lsaconroe87]

So I have 319e that when it reverse the machine made a loud noise and I lost forward and reverse. When I went to turn machine off, and tried to turn it back on it the lights would just flash and turn right off. I checked for active codes and got this at the menu, ECU 522597.09. Also the pictures below as well.

 

[mg2361]

First, complete machine serial numbers are a must for accurate information gathering, so please post up the S/N.

Is that code active? Stored? That code indicates a loss of communication from the ECU. Fuses good? The little red wire at the battery positive post securely attached to the positive battery clamp?

 

[Lsaconroe87]

1T0319EJCEJ263415

The code is an active code. I did check all the fuses. The fuses were all good. I did check the battery but there was not a little red wire at the terminal. I did find a black 12 guage wire from the alternator that looked like it was rubbing along the engine but no burn marks. I did include two pictures with more code after I plugged in with my computer.

 

[Lsaconroe87]

Before all this was happening. The machine was having throttle pedal issues and as well as the manual throttle knob. The machine would only throttle up on its own.

 

[mg2361]

Your title says remote start not working. Do you have the remote start box and it is not working?

 

[Lsaconroe87]

Yes the remote start box is not working as well. It lights up like it's sending signal to starter and then shuts off.

 

[mg2361]

All the grounds and cables been thoroughly checked?

Can you post a video of lights in question showing the issue?