wisdumb
Member
From 10 0 clock to 2 o clock.
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
John Deere 310C won’t go forward after rebuild, new hydraulic leak.
- Thread starter wisdumb
- Start date
wisdumb
Member
From 10 o clock to 2 o clock.
mg2361
Senior Member
That is where the forward pressure port is at. Must be an assembly issue. Don't know what else to offer since I can't lay eyes on it.
wisdumb
Member
When I get time to pull it out again. I will give more information.
Steve Austin
Senior Member
When you remove the shuttle see if you can turn the output shaft and input shaft by hand. You should be able to turn output shaft by hand may need channel locks for input shaft both should turn fairly easily. If not than something is not lined up correctly, and front cover may not be torquing down against gasket tight enough to seal off.