Jamesdigger67
Active Member
Hi all new member here but been diggin ditches for sometimes now and I’m getting ready to tackle the cylinder repack job on my 410d standard boom non extendahoe. I was hoping somebody might could pass along the rod end bolt torque specs on the boom,crowd,bucket,swing,
Outrigger and loader cylinders if anybody had access to it. I sure would appreciate it, james river wants over 7k just to do the backhoe and outriggers where I’m at so I’m wanting to avoid it. I know I can do the job but want to try and get it as close as I can.
Thanks for taking the time to read this
Outrigger and loader cylinders if anybody had access to it. I sure would appreciate it, james river wants over 7k just to do the backhoe and outriggers where I’m at so I’m wanting to avoid it. I know I can do the job but want to try and get it as close as I can.
Thanks for taking the time to read this