6K7200 frame assembly .I need to know what this part is. The local dealer said it is 7K-9375 and referred to it as a pin. Its the part my finger is actually on.
Thanks for your response. The serial number is 11K8654 and if you will review the new pic you will see that over time it has gotten so that the inside piece is no longer held tightly in place which makes the arms and bucket shiftMight I ask why you are looking for this part..?
Also can you take a photo from a bit further away in order to give context.
A machine Serial Number would also help.
Now the problem is obvious. In fact there is a far easier solution than to try to replace the piece you are pointing to in the photo of your first post. It is a process known as line-boring. Basically a piece of equipment is used to machine the hole so that it is clean and of a consistent diameter but oversized. At this point in time it is most likely somewhat oval in shape. Then the bore is welded internally to reduce the internal diameter until it is undersized, then finally is it machined to bring it back to the specified size for the pin to fit without that huge gap shown in your 2nd photo.Thanks for your response. The serial number is 11K8654 and if you will review the new pic you will see that over time it has gotten so that the inside piece is no longer held tightly in place which makes the arms and bucket shift