Ricardo Cotte
Well-Known Member
Hello and Happy Easter to all.
I'm in the process of attaching a hydraulic brush cutter on my backhoe.
My machine has factory lines installed but being a second hand unit I don't know if, how or what was ever connected to these. They have plugs at the end for which I acquired quick flat face connectors.
Would it be in order to do a flush of these hoses/circuit before operating this new brush cutter?
If so, what would be a proper and safe way of doing this?
This 310SJ has 3,360 hrs. and it is running good as far as I know. Attachment will run at 25 gpm at most.
Am I worrying too much about this?
Thanks for your advice.
I'm in the process of attaching a hydraulic brush cutter on my backhoe.
My machine has factory lines installed but being a second hand unit I don't know if, how or what was ever connected to these. They have plugs at the end for which I acquired quick flat face connectors.
Would it be in order to do a flush of these hoses/circuit before operating this new brush cutter?
If so, what would be a proper and safe way of doing this?
This 310SJ has 3,360 hrs. and it is running good as far as I know. Attachment will run at 25 gpm at most.
Am I worrying too much about this?
Thanks for your advice.