Got it out .
Cylinder bore did get marked up a bit but the copper sealing washer on the injector bottom didn't get touched.
Took maybe half hour. Drill a little, stick vacuum tube in bore and suck debris. Repeat many times. Now I just have to figure how to put it back together! Got a new set of injectors from perkins.
Oh and in case anyone else needs to tackle this in the future, I'd recommend going slightly smaller with your bit size.
The injector diameter is 21.5mm and I used a 21mm cutter. I would go a little smaller if I had to do it again.
Cylinder bore did get marked up a bit but the copper sealing washer on the injector bottom didn't get touched.
Took maybe half hour. Drill a little, stick vacuum tube in bore and suck debris. Repeat many times. Now I just have to figure how to put it back together! Got a new set of injectors from perkins.
Oh and in case anyone else needs to tackle this in the future, I'd recommend going slightly smaller with your bit size.
The injector diameter is 21.5mm and I used a 21mm cutter. I would go a little smaller if I had to do it again.