greygizmo
New Member
Starting a couple months ago I noticed I was having a hard time moving the blade control lever when first starting the machine. Eventually, it would move and all would be good the rest of the session.
In the past I tried more grease on the cylinder pins, using the bucket to raise the front end and quickly "dropping" the blade into the ground, etc.
Today the weather is about 15F and I can't get the blade loose at all.
Honestly I'm not sure if the issue is at the cylinder or in the hydraulic valve that the control lever connected to.
What would you guys try?
In the past I tried more grease on the cylinder pins, using the bucket to raise the front end and quickly "dropping" the blade into the ground, etc.
Today the weather is about 15F and I can't get the blade loose at all.
Honestly I'm not sure if the issue is at the cylinder or in the hydraulic valve that the control lever connected to.
What would you guys try?