Case 580K Help identifying wire that fell off

[styxplo]

I was pressure washing the other day and somehow blasted a wire off. I can’t find out where it is supposed to connect. As far as I can tell everything seems to be working properly. It’s under the small hood where the hydraulic fill and diesel fill are. I can’t find it on the print. It’s under the master cylinder. It can only go so many places based on its length. I think it is white with a red stripe??? And has a female bullet connector. Anyone recognize it??? Thanks

 

[alrman]

It looks dirty inside... as if it was never hooked up to anything before.

 

[styxplo]

It does. That never even occurred to me. I will have to get a better look tomorrow. I’ve wrenched on old Cletus a lot. Never noticed it before.

 

[Steve Favia]

I was pressure washing the other day and somehow blasted a wire off. I can’t find out where it is supposed to connect. As far as I can tell everything seems to be working properly. It’s under the small hood where the hydraulic fill and diesel fill are. I can’t find it on the print. It’s under the master cylinder. It can only go so many places based on its length. I think it is white with a red stripe??? And has a female bullet connector. Anyone recognize it??? Thanks

Hard to tell from the pictures,for some reason I can’t blow up the picture. Went out and looked at my 580k,looks like it goes to my selinoid for my ether ( cold start system) ?

 

[styxplo]

I checked the wiring diagram.....Cold start is grey/orange. I thinks that's it. It also makes sense because I don't have that option. Mystery solved. Thanks

 

[Steve Favia]

I checked the wiring diagram.....Cold start is grey/orange. I thinks that's it. It also makes sense because I don't have that option. Mystery solved. Thanks

You’re welcome,glad to help!