kurt ackerman
Active Member
- Joined
- Dec 12, 2020
- Messages
- 25
- Location
- louisville ky
- Occupation
- little bit of this and some of that
hey guys I am new to this board and I am Kurt. I own 3 pieces of equiptment 1 of is this stump grinder. Recently it the hydrolic cylinders started leaking. I have been able to remove 4 of the 5 cylinders. I cannot for the life of me get the last 1 out of the longest cylinder. It sits below under the engine. All have had cotter pins in them that i removed and was able to pound the old out.. Not this 1.. I have welded a nut onto the frame and tried to push it out the other side but ends up bending the 3/4 bolt and then my welds break. I have tried everyway i can think of and have not found anything online to help.
thanks kurt
thanks kurt