I’m thinking about redoing the positive and negative leads from my 555e machine and wanted to get opinions on cable sizing. I’m not an electrical guru, but they look to be 2/0.
The battery that’s in the machine is a 4D. Cranking amps is 1290 and CCA is 1050.
It also has a negative cut-out that I will keep and I will also replace the braided wiring that is probably original. That is, unless someone thinks these can be reused with a good ole scrubbing. This isn’t my picture as I borrowed it from another thread, but will give an idea of what I’m talking about.
Any thoughts?
The battery that’s in the machine is a 4D. Cranking amps is 1290 and CCA is 1050.
It also has a negative cut-out that I will keep and I will also replace the braided wiring that is probably original. That is, unless someone thinks these can be reused with a good ole scrubbing. This isn’t my picture as I borrowed it from another thread, but will give an idea of what I’m talking about.
Any thoughts?