I have an Onan P224G-I engine, spec, 10842C, on a Woodmizer mill that will not stay running at idle without partial choke, at full speed it works fine.
It is not the original engine, a pretty low hour replacement in otherwise good condition.
Is anyone familiar with this engine? I have the service manual and have gone through all the carb and governor settings and adjustments, moving the idle jet screw does not change anything.
Seems like the idle jet is clogged.
Is the jet removeable on these carbs? are they easily rebuildable? Advise?
Thanks.
It is not the original engine, a pretty low hour replacement in otherwise good condition.
Is anyone familiar with this engine? I have the service manual and have gone through all the carb and governor settings and adjustments, moving the idle jet screw does not change anything.
Seems like the idle jet is clogged.
Is the jet removeable on these carbs? are they easily rebuildable? Advise?
Thanks.