Hi folks some help needed. CNH B115B Stear wheel selector wont respond all three position lights go bright. Right after starting engine everythihg goes right all positions respond to a selector, then after 3-4 minutes it wont respond, and stay on one istalled position. Stop the engine , start it immedietly, and it again works fine and all operations work. Need to decypher error code hardwear 87521757 id 614 , softwear pn 47415976 id 1096
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
4WS solenoid
- Thread starter Honcho
- Start date
NH575E
Senior Member
That hardware number is the instrument cluster.
If you suspect a solenoid look at the coil to see if it looks burnt. The 4WD solenoid coil on my 575E burned up. NH didn't supply it without the solenoid and I matched the number embossed on it up and found a coil for $20. Just had to splice the plug from my old coil on it.
If you suspect a solenoid look at the coil to see if it looks burnt. The 4WD solenoid coil on my 575E burned up. NH didn't supply it without the solenoid and I matched the number embossed on it up and found a coil for $20. Just had to splice the plug from my old coil on it.
Now look what I ve done. There are four of them solenoids. Two got warm, one a bit more warm, and one is cold, So i dismanteled them and changed their places. Though I guess if only chahged their plug places I d have same result . Now I ve 2ws, and a crab. 4ws wont respond, But got no error on a dash. So I can work it untill get a new colenoid. I guess it is gonna cost a fortune here, haven t checked up yet. But still not sure what was the trouble wire cut, short, or solenoid fail.
Attachments
NH575E
Senior Member
That number comes up in a global search. You should be able to locate it somewhere.
Rexroth r901073024 crosses to 4WE 6 GA6X/OFEG12N9K4 on this page.
https://www.pneu-hyd.co.th/rexroth—...ทิศทาง/directional-spool-valves.html?start=10
The 4WE 6 GA6X/OFEG12N9K4 shows up here also.
https://www.powerpartspro.com/hydraulics/hydraulic-pumps/rexroth?start=170000
Rexroth r901073024 crosses to 4WE 6 GA6X/OFEG12N9K4 on this page.
https://www.pneu-hyd.co.th/rexroth—...ทิศทาง/directional-spool-valves.html?start=10
The 4WE 6 GA6X/OFEG12N9K4 shows up here also.
https://www.powerpartspro.com/hydraulics/hydraulic-pumps/rexroth?start=170000
http://fluitech.com.ua/product/bosch-rexroth/bosch-rexroth-stranitsa-23/
I can't read it so don't know where they are, but closer to you than to me.
Joe H
Well info from Russian machine forum. those two contacts that are on a pic must show 5om resistance, if it less it is not working. So I checked it up, I got two solenoids that show 3 om resistance. Well now I expect two new solenoids. 