• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

cat 289d

  1. Tj345

    Cat 289D

    Hello everyone Hoping someone can help me with a running gear schematic diagram. The four axels that hold the frame are worn out. I need a schematic to see exactly what I need to fix it. Please see attached photos of the worn out part and serial number. Thanks in advance!!
  2. F

    289D Drive motor speed sensor faults 2685-8

    I have a 289D, TAW05187, that has abnormal drive motor frequency faults for all 4 speed sensors (2685, 2686, 2687, 2688). It has the intermittent fault that only shows when moving the machine. I've gone through the service manual and all the wiring checks fine according to the troubleshooting...
  3. B

    Cat 289D pushing coolant into overflow tank

    We have a Cat 289D that is pushing it's coolant into the overflow tank after a day of moving dirt. I just replaced the temp regulator (P/N: 389-5308), put new coolant in and sprayed out the fins on the radiator. I was hoping to get a troubleshooting guide, any old tips, or just some Insite on...
  4. N

    Cat 289d Cold planner electric connection

    Hello everyone, I’m not sure if this is the right place to post, so feel free to let me know if I should open a new topic. I have a Caterpillar 289D, serial number TAW05718, and I recently purchased a Simex PL5020. On the Caterpillar, I have a 14 pin connector with active 9 wires. On the...
  5. S

    2014 Cat 289D - only a few lights, nothing else

    I have a cat 289D that is only displaying a few red indicator lights up in the top right corner. The CAT display screen doesnt light up. Machine will crank over, but does not start. Strange thing is, the lights (parking brake light, hydraulic pressure light) are on all the time, even with the...
  6. M

    Cat 289D brush cutter problems

    I have a Cat 289D compact track loader Serial number CAT0289DCTAW00565 when I put on continuous flow to brush cutter the machine will move for a few seconds and then wont move at all until I stop flow to brush cutter. If I only go about half way on the roller knob to limit the continuous flow...
  7. O

    CAT 289D3

    Hi all, I'm new here, it is my first post. I registered because I've found very helpful information about CAT 289D3. The thing I couldn't find is the electrical diagram of this connector: I need to know which PINS work with the buttons on the joystick. Also I need to know which is the...
  8. I

    CAT 289D: DIY install of ride control & hydraulic quick coupler?

    I have a 289D and CAT ETL and a little bit of redneck ingenuity to work on my own machine. Has anyone tried adding ride control and/or hydraulic quick coupler to their machines? It seems like it can be done but I can't find many people who've attempted it without paying big $$ to the CAT...
Top