• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. K

    Vermeer feed rollers not working

    Hi I’m working on a vermeer bc1800xl chipper with psi engine. The feed rollers stop working after a few hours of use. The tech gauge under diag shows active codes… -SPN 695 FMI 9 OC 3 abnormal update rate -SPN 639 FMI 12 OC 2 bad intelligent device -SPN 639 FMI 12 OC 1 bad intelligent device I...
  2. K

    Terex L20 expansion tanks?

    I have a terex loader model L20 I believe. On the right side of the machine by the rear tire are two tanks one smaller than the other. One tank goes to the brake valve and the other goes to the bucket control valve. My question is are these hydraulic expansion tanks, what is there puspose, and...
  3. K

    Daewoo 601 warning light?

    Hi I have just acquired a daewoo 601 but I do not have an operators manual. When the machine is started the stop light, exclamation light, whine over temp light, hydro over temp light, hydro filter light, and one other red light looks like a line with a circle next to the fuel gauge illuminates...
  4. K

    Michigan 125a

    Also any ideas wear i can get parts?
  5. K

    Michigan 125a

    Yes hydraulics work great the fiber gear is in great shape.
  6. K

    Michigan 125a

    Yes i did check the clutch pressure 6 months ago was perfect transmission also worked flawlessly. But the last time i moved the machine i had to rev the **** out of it just to get it to crawl. Seemed to me it was the converter because say, low range forward I can rev it as much as i want and the...
  7. K

    Michigan 125a

    Hi i have a 1970 Michigan 125a wheel loader rear wheel steer. machine started moving sluggish so I changed and checked the trans fluid, didn't seem to do much. then one day i went to move the machine and would not move. The drive shaft between the torque converter and transmission would spin in...
Top