• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by tharden

  1. T

    287B wiring schematics and ideas

    They fan does spin right up now after adding fluid. If you play with the buttons long enough you can get control over the loader and the drive system sounds like the brakes wont release though.
  2. T

    287B wiring schematics and ideas

    It was low on fluid. Added fluid and the attachment lock works and the aux works. Still dont have bucket or track controls. I will dig a little deeper.
  3. T

    287B wiring schematics and ideas

    My friend will be by the machine tomorrow. I will have him check. Thank you for the quick reply. You helped me in the past with my D4H and I still appreciate it.
  4. T

    287B wiring schematics and ideas

    My friend just got a 287b. Engine runs but none of the hydraulic functions plus travel will work. We pulled the harness to the left side ecu and the plug was full of oil. I am wondering if anyone may have a wire schematic of the machine an maybe a trouble shooting guide. Park brake light...
  5. T

    1987 D4H series II gauges mechanical or Electronic..dead either way

    You have a fuse box behind the panel for your steering levers. The old twist lock fuse holders can corrode and not make contact.
  6. T

    Moving a TL26 Takeuchi

    Thanks for the info. I will have to spin it 90 degrees and about ten feet to the trailer. I got a 24,000 winch this go around and do as you say and slide some two by fours under the track. I'll spray it down with soap too.
  7. T

    Moving a TL26 Takeuchi

    I bought a TL26 but will have to pull it on my trailer. Do I need to disengage the drive motor or drive unit for it to roll? It has been sitting for a while.
  8. T

    Cat D4H blade attachment model

    2 UMD
  9. T

    Cat D4H blade attachment model

    Thank you sir. I do appreciate your help.
  10. T

    Cat D4H blade attachment model

  11. T

    Cat D4H blade attachment model

    There is a IU3347X on the tower.
  12. T

    Cat D4H blade attachment model

    The 6yxxxx was what I thought could be the c frame for it. I'm looking at my parts list but i am having a hard time comprehending how the serial number matches the correct c-frame.
  13. T

    Cat D4H blade attachment model

  14. T

    Cat D4H blade attachment model

  15. T

    Cat D4H blade attachment model

    I have a 1989 D4H that I need to replace some pins and bushings in the blade c frame at the tractor frame and the pin at the blade tower. I have called the cat dealer but they can not figure out which blade I have. The ser# is 8PB03466. I also have a parts list as well but can not figure out...
See more
Top