-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
Recent content by KWhauling
-
K
Warning light
Can someone please tell me what this light is d6n cat -
K
Caterpillar d6n very hard to start
Thanks I just ordered one any chance on a part number for the heui pump just curious as to the cost at that will be my next step I'm going to replace that valve that doesn't help we're going to do a couple pressure tests on the pump hopefully the valve will solve the problem -
K
Caterpillar d6n very hard to start
Would you happen to have part number for pressure relief valve? Thanks -
K
Caterpillar d6n very hard to start
It's been a little hard starting in the morning but it was single digits or teens I did give it a shot of either I was just assuming it was because of cold we would start it and run it all day I think it came on quick . One thing I did notice there was fuel coming out the primer when I pumped... -
K
Caterpillar d6n very hard to start
Sorry I talked to my phone I don't type that's why there's no punctuation -
K
Caterpillar d6n very hard to start
I have a caterpillar d6n serial number cck00666 it's very hard to start even when it's warm I change both fuel filters when you crank it there's a lot of white smoke coming out of the exhaust once it gets started it seems to run fine couple days ago it bogged down for a minute or two we assumed... -
K
Installing drive shaft in final drive d6n
Well we got it made a pipe up with the bolt welded on the end in order to get the center shaft where it had to be while we were pushing it in we turn the PTO a little bit and it went right into place then in order to get the left shaft in we had a bar and turn the sprocket a little bit and the... -
K
Installing drive shaft in final drive d6n
I have a d6n cck00666 we had to pull transmission we can't get the drive shaft on the left side while sitting in seat in all the way we think we have the center shaft where it belongs any help or info is appreciated thanks Kevin -
K
D6N stopping
I want to especially thank you you where very helpful we have it torn down parts are expected today and reassembly on Monday I'll post an update when completed thanks again -
K
D6N stopping
Ok follow up we pulled the transmission the first gear clutch seal was blown out and a couple of friction disc where bad on one side thanks to everyone for the help -
K
D6N stopping
Is it possible that it could be priority valve I have a mechanic saying to check that first before pulling the screen I'm really getting confused thanks again