mg2361
Senior Member
the HLR creeps a little when going into the neutral position...is this a simple adjustment?
It might be the HLR linkage adjustment. Or it could be clutch plates warping and starting to drag. Which way does it creep, forward or reverse? Check your HLR linkage for slop. You should get yourself the service manual SM2064.
Also I was told to "block" the steering levers back to try and prevent the dry steering clutches from freezing up...good idea?
If your machine sits a lot, it can't hurt. Bare in mind that if it sits long enough the clutch linkage inside the steering housing could also seize, whether your levers are blocked or not. It would probably be better to just work the levers on a regular schedule.