What brand of pin on bucket teeth do you guys like. I'm wanting to replace mine on one of my excavator buckets, for some reason I'm forever replacing the teeth, they fall off and we lose them, then run a day or so without the tooth on them, then the holder is worn enough it won't fit a new tooth tight and from then on its downhill attempting to put new teeth on and keeping them on.
I've thought the holder itself should be bolted on, have a few of them on other buckets and for some reason if the holder gets worn, they should be much easier to replace. On all the buckets with bolt on holders, we've never replaced a single holder, not even replaced a tooth on them either. I've checked and those holders are not large enough to fit on my thicker cutting edges on my excavator buckets.
Basically, what does everyone use, how do you like them, and would you put them on new again, holders, teeth and new cutting edge again? Would you recommend welding the holders on or bolt or is it a toss up for an excavator? Thanks in advance
I've thought the holder itself should be bolted on, have a few of them on other buckets and for some reason if the holder gets worn, they should be much easier to replace. On all the buckets with bolt on holders, we've never replaced a single holder, not even replaced a tooth on them either. I've checked and those holders are not large enough to fit on my thicker cutting edges on my excavator buckets.
Basically, what does everyone use, how do you like them, and would you put them on new again, holders, teeth and new cutting edge again? Would you recommend welding the holders on or bolt or is it a toss up for an excavator? Thanks in advance