Billy Bob Deluxe
Member
I recently bought an angle blade, that I saw working prior to purchasing, but cannot get any auxiliary hydraulic flow on my 2004 Cat 216B, 0216BERLL00474. I purchased the OMM and tried the sequence suggested in there and also tried the Hydraulic Lockout switch as suggested in another similar thread.
It’s darn near 30 below C and I would like to try everything I can before lifting the cab and blind troubleshooting.
Any suggestions for where to start?
It’s darn near 30 below C and I would like to try everything I can before lifting the cab and blind troubleshooting.
Any suggestions for where to start?