kapope712
Member
Working on my 97 600A with Deutz. It seems that my travel and possibly my control speeds are stuck in either creep mode or turtle (if there’s a difference). Throughout different movements and switchology I can hear the 3 different RPM ranges that the MX manual mentions.
I’m new to this machine and been going over some issues with it. I found what I believe to be the boom level sensor unplugged. I thought maybe this was the issue but after plugging it back in there was no change (the manual states anytime the boom is above the horizon the machine will creep).
Thoughts on the sensor just being bad? Is this switch normally open or closed? Can I jump it for Diagnosis purposes ONLY? Or should I look in some different places?
Any help would be much appreciated!!!
I’m new to this machine and been going over some issues with it. I found what I believe to be the boom level sensor unplugged. I thought maybe this was the issue but after plugging it back in there was no change (the manual states anytime the boom is above the horizon the machine will creep).
Thoughts on the sensor just being bad? Is this switch normally open or closed? Can I jump it for Diagnosis purposes ONLY? Or should I look in some different places?
Any help would be much appreciated!!!