2112
Well-Known Member
I was kind of thinking the same thing, I picked one up last night. Probably not install until tomorrow, work late today
Got a NAPA coil # IC14SB
Don't know the number, but surely you asked for 12V with internal resistor, and surely he gave you one.
Yes I did get the tank filled to the brim (9.5 gallons in a 12 Gallon tank)
Never knew the gallons, always bought it by the pound tank -20 lb, 33, and 40.
Temp tape? Do you mean Temperature or temporary? I was wondering if there is a paint I can use to insulate the rotor stalk?
Sorry to be so dense, do you mean to put the tape under the points assembly where it hangs on the pivot shaft?
I tried to sketch an arrow where I think you are telling me to place the insulating tape. Am I way off? are you saying to place it everywhere the points assembly makes contact with the plate?
.
Or did you mean under the stationary part? I labeled the insulator under that part "B". It appears to be in good condition.
TO INSULATE THAT POST IT IS ON from all that is fastened on, to or thru it.
.